HIKVISION DS-TCG227-A Series User Manual

User Manual of DS-TCG227-A Series Entrance/Exit Capture Unit
35
5. Click Save to save the settings.
6.3.2.7 Configure Service
Purpose:
You can enable user lock. Then if the admin logs in to the capture unit incorrectly for
7 times continuously, the admin will be locked for 30 minutes. If the operator logs in
to the capture unit incorrectly for 5 times continuously, the operator will be locked for
30 minutes.
Steps:
1. Go to Configuration > Device Configuration > System Configuration >
Service.
Figure 6-18 Enable User Lock
2. Check Enable User Lock.
3. Click Save to save the settings.
After the capture unit is powered off and reboots, the user lock will be disabled.
6.3.2.8 Configure DST
Steps:
1. Go to Configuration > Device Configuration > System Configuration > DST.
Figure 6-19 Enable DST
2. Check Enable DST, and you can set Start Time, End Time and DST Bias.

HIKVISION DS-TCG227-A Series Specifications

General

Brand	HIKVISION
Model	DS-TCG227-A Series
Category	Security Camera
Language	English