User Manual of DS-TCG227-A Series Entrance/Exit Capture Unit
34
3. Synchronize time.
Synchronizing Time by NTP Server
(1) Check NTP to enable the function.
(2) Configure the following parameters:
Server Address: IP address of NTP server.
NTP Port: Port of NTP server.
Interval: The time interval between the two synchronizing actions with NTP
server.
Figure 6-15 Time Sync. by NTP Server
If the capture unit is connected to a public network, you should use a NTP server that
has a time synchronization function, such as the server at the National Time Center
(IP Address: 210.72.145.44). If the capture unit is set in a customized network, NTP
software can be used to establish a NTP server for time synchronization.
Synchronizing Time Manually
Click to set the system time from the pop-up calendar.
You can also check the Synchronize with PC to synchronize the time of the capture
unit with that of your computer.
Figure 6-16 Manual Time Sync.
4. Click DST tab to enable the DST function and set the date of the DST period.
Figure 6-17 DST Settings
To Next Page
Loading...
