HIKVISION HWN-4108MH-8P - Page 41

Add Network Camera Manually
Before You Start
●
Ensure your network camera is on the same network segment with your video recorder.
●
Ensure the network connecon is valid and correct.
●
Ensure the network camera is
acvated.
Steps
1.
Go to
Conguraon → Camera → IP Camera .
2.
Click .
3.
Set network camera parameters, including IP address, protocol, management port, etc. You can
check Use IPC
Acve Password to use the device password to add network camera(s).
4.
Oponal: Click Add More to add another network camera.
5.
Click OK.
Figure 5-8 Add Network Camera
Edit Connected Network Camera
You can edit the IP address, protocol and other parameters of the added network cameras.
Steps
1.
Go to
Conguraon → Camera → IP Camera .
2.
Click to edit the selected camera.
Channel Port
If the connected device is an encoding device with mulple channels, you can select the
channel port No. to choose a
connecng channel.
3.
Click OK.
Network Video Recorder User Manual
28