brims of the blocks in the motion detection areas will flicker in red/green/blue colors.
Notes: iVMS-2000 supports up to 8 regions for each camera’s motion detection, and
there is 7 levels for sensitivity.
Set Video Tamper Area (Figure 6-38):
Figure 6-38 Set Video Tamper Area
Click [Region] during video tamper alarm modification and enter “Set Video Tamper Area”
dialog box. The operation steps for Add/Modify/Move/Delete areas are similar to motion
detection area configuration, and users can adjust the sensitivity level and click [Start Test].
If there is video tamper detected in the region, the brims of the blocks in the motion detection
areas will flicker in red/green/blue colors.
Notes: iVMS-2000 supports 1 region for each camera’s video tamper detection, and
there is 3 levels for sensitivity. (For analog camera inputs, the video tamper is set
as whole-region detecting mode and users does not need to configure the region)
To Next Page
Loading...
