shown in Figure 3-25. In addition to above operations, the menu contains a “disable”
function. You cannot recall a disabled preset. The status bar will display “Forbidden” after
the corresponding preset has been disabled.
Figure 3-25 Right-click Menu
3.6.2 Patrol
Patrol can make it more convenient to switch between several presets.
Click “Patrol” to enter patrol configuration area as shown in Figure 3-26.
Figure 3-26 Patrol operating area
(1) Add patrol sequence
Click button and prompt Config patrol box as shown in Figure 3-27, input
patrol name and select presets in the drop-down list which you want to add to the patrol.
Then input the dwell time to stay, click “Add” to complete adding preset in the patrol.
Note:
Each patrol should have a unique name.
You can remove presets from a patrol by selecting one preset and clicking
button “Delete”.
(2) Modify patrol sequence.
Click button and the patrol configuration dialog will prompt as shown in Figure
3-27. Users could rename a patrol as well add presets to the patrol or delete presets
from the patrol by clicking corresponding buttons in patrol configuration dialog. Click
To Next Page
Loading...
