2 Installation and Removal
2.1 Installation
Please refer to the following steps during iVMS-2000 installation.
Step1: Insert the iVMS-2000 installation CD into the PC CD-ROM, and run
on the CD. The install shield dialog box will be displayed (Figure 2-1), and dialog box as Figure
2-2 will be displayed a few seconds later (the time interval depends on the PC configuration).
Figure2-1 Preparing to Install
Step2: Click “Next (N)” (Figure 2-2) and select the installation path (Figure 2-3), or click
“Cancel” to cancel the installation.
To Next Page
Loading...
