Figure 6-51 Email Configuration
Users need an mail account which supports SMTP to send the email. Click [SMTP
Settings] and set the Email account for the sender (Figure 6-52).
Figure 6-52 SMTP Settings
After SMTP settings are properly configured, users can click [Test] and test if this
account can send the emails correctly. The SMTP account will send a test email to its
own address then, and if the users receive the test email properly, please follow the
operation steps below.
ConFigure receiver address, CC, subject, content, and click [Save]. For multiple
receiving address, please separate each of them with “;”.
Notes: The alarm audio and email configuration can also be visited in alarm linkage
configuration interface.
To Next Page
Loading...
