Step5: In Figure 2-5, a WinPcap installation wizard will pop up (software can not
automatically detect and add IP cameras if WinPcap is not installed on the system), Click
“Next” to start WinPcap installation (Figure 2-8). Click “Next” to continue, or click “Cancel” to
cancel Installation and go to the Installation Complete Interface directly (Figure 2-12).
Figure 2-6 Ready to Install WinPcap
If WinPcap is already installed on the PC, warning message box will prompt (Figure 2-7).
Click “OK” to reinstall WinPcap, or click “Cancel” to skip WinPcap installation and go to
Installation Complete Interface directly (Figure 2-12).
Figure 2-7 Warning: WinPcap is already installed on the PC
Step6: In Figure 2-8, click “Next” to enter the license agreement screen (Figure 2-9).
Click “Back” to return to Figure 2-6, or click “Cancel” to skip WinPcap Installation and go to
Installation Complete Interface directly (Figure 2-12).
To Next Page
Loading...
