Select the camera in the “Modify Record Schedule” dialog box, and click [Next] to
configure record schedule in the prompt dialog box (Figure 6-20):
Figure 6-20 Add Arm Schedule for Record Schedule Configuration
The default record schedule is set as 24-hour arm & motion detection mode, and users
can modify the schedule via configuration steps below:
1. Click [Delete] / [Delete All] to delete current record schedule;
2. Click [Motion] / [Schedule] to select record mode;
3. Drag the mouse in each day’s time bar to add record schedule (support up to 8
pieces of time schedule per day), and each pieces of time schedule can be modified
in position and length, users can also copy the time settings to the whole week;
4. Click [OK] to complete the record schedule settings.
Select relative camera in the drop-down list of [Camera Name] to switch to this camera’s
record schedule settings.
Click [Setup] in [Motion Detect Area] to set motion detect area.
Click [Setup] in [Encoding Parameters] to set encoding parameters for the camera
(Figure 6-21).
To Next Page
Loading...
