HIKVISION Network Audio/Video Encoder User Manual

User Manual of DS-6700 Series Audio/Video Encoder
34
7.2 Configuring Time Settings
Steps:
1. Click Remote Configuration > Device Parameters > Time Settings to enter the Time Settings interface:
Figure 7.2 Time Settings
2. Select the Time Zone.
Select the Time Zone that is closest to the device’s location from the drop-down menu.
Figure 7.3 Time Zone Settings
3. Configure the time synchronization by NTP server or by manually.
 Configuring Time Sync by NTP Server
A Network Time Protocol (NTP) Server can be configured on your device to ensure the accuracy of system
date/time.
If the device is connected to a Dynamic Host Configuration Protocol (DHCP) network that has time server
properties configured, the camera will synchronize automatically with the time server.
Enable the NTP function by checking the checkbox, and configure the following settings:
NTP Server: IP address of NTP server.
NTP Port: Port of NTP server.
Interval: The time interval between the two synchronizing actions with NTP server. It can be set from 1 to
10080 minutes.
Figure 7.4 Time Sync by NTP Server

HIKVISION Network Audio/Video Encoder Specifications

General

Brand	HIKVISION
Model	Network Audio/Video Encoder
Category	Media Converter
Language	English