Fingerprint Access Control Terminal·User Manual
110
Door Locked Time: After swiping the normal card and relay action, the timer for locking
the door starts working.
Door Open Duration by Card for Disabled Person: The door magnetic can be enabled with
appropriate delay after disabled person swipes the card. By default, it is 15s.
Door Open Timeout Alarm: The alarm can be triggered if the door has not been closed.
By default, it is 30s.
Enable Locking Door when Door Closed: The door can be locked once it is closed even if
the Door Locked Time is not reached.
Duress Code: The door can open by inputting the duress code when there is duress. At the
same time, the client can report the duress event.
Super Password: The specific person can open the door by inputting the super password.
Dismiss Code: Input the dismiss code to stop the buzzer of the card reader.
Notes:
The Duress Code, Super Code, and Dismiss Code should be different.
The Duress Code, Super Password, and Dismiss Code should be different from the
Authentication Password.
3. Click Save button to save parameters.
Card Reader Parameters
Steps:
1. In the device list on the left, click to expand the door, select the card reader name and you
can edit the card reader parameters on the right.
2. You can editing the following parameters:
Nickname: Edit the card reader name as desired.
Enable Card Reader: Select Yes to enable the card reader.
To Next Page
Loading...
Need help?
General
