To Next Page

To Previous Page

Fingerprint Access Control Terminal·User Manual

111

 OK LED Polarity: Select the OK LED Polarity of the card reader mainboard.

 Error LED Polarity: Select the Error LED Polarity of the card reader mainboard.

 Buzzer Polarity: Select the Buzzer LED Polarity of the card reader mainboard.

 Minimum Card Swiping Interval: If the interval between card swiping of the same card is

less than the set value, the card swiping is invalid. You can set it as 0 to 255.

 Max. Interval When Inputting Password: When you inputting the password on the card

reader, if the interval between pressing two digits is larger than the set value, the digits

you pressed before will be cleared automatically.

 Enable Failed Attempts Limit of Card Reading: Enable to report alarm when the card

reading attempts reach the set value.

 Max. Times of Card Swiping Failure: Set the max. failure attempts of reading card.

 Enable Tampering Detection: Enable the anti-tamper detection for the card reader.

 Detect When Card Reader is Offline for: When the access control device cannot connect

with the card reader for longer than the set time, the card reader will turn offline

automatically.

 Buzzing Time: Set the buzzing time of the card reader.

 Card Reader Type: Get the card reader’s type.

 Fingerprint Recognition Level: Select the fingerprint recognition level in the dropdown list.

By default, the level is Low.

Note: Only DS-K1T804 series supports setting the Fingerprint Recognition Level parameter.

3. Click the Save button to save parameters.

5.9.2 Card Reader Authentication

Purpose:

You can set the passing rules for the card reader of the access control device.

Steps:

1. Click Card Reader Authentication tab and select a card reader on the left.

2. Click Configuration button to select the card reader authentication modes for setting the

schedule.

Notes:

 The available authentication modes depend on the device type.

 Password refers to the card password set when issuing the card to the person. Chapter 5.6

Person Management.

1) Select the modes and click to add to the selected modes list.

You can click or to adjust the display order.

HIKVISION UD06644B User Manual

Other manuals for HIKVISION UD06644B