To Next Page

To Previous Page

Fingerprint Access Control Terminal·User Manual

4.5.1 Configure Access Control Parameters

Steps:

1. Select ACS (Access Control System) in the access control system interface to enter the

parameters setting interface.

2. Edit the parameters.

Terminal

Authentication:

Configure the terminal authentication mode, including

“Card/FP (Fingerprint)”, “Card”, “Fingerprint”, “Card and PW

(Password)”, “Card and FP (Fingerprint)”, “FP (Fingerprint) and

PW (Password)”, “Card and FP (Fingerprint) and PW

(Password)”, and “Card/PW (Password) (The password here

refers to the card ID No. and the user password)”.

Sub Reader

Authentication:

Configure the sub reader authentication mode, including

“Card/FP (Fingerprint)”, “Card”, “Fingerprint”, “Card and PW

(Password)”, “Card and FP (Fingerprint)”, “FP (Fingerprint) and

PW (Password)”, “Card and FP (Fingerprint) and PW

(Password)”, and “Card/PW (Password) (The password here

refers to the card ID No. and the user password)”.

Door Magnetic:

Configure the door magnetic status, including Remain Closed

and Remain Open.

Note: By default, the magnetic status is Remain Closed.

Lock Action

Time:

Configure the action time after the door opening. After the

action time, the door will be locked.

Note: Available lock action time duration is from 1 to 255s.

Door-Open

Timeout Alarm:

Configure the maximum time duration for door opening. If the

door-open time has exceeded the configured value, it will

trigger an alarm.

Auth Times

Exceeded

Alarm

Configure the maximum times for authentication.

HIKVISION UD06644B User Manual

Other manuals for HIKVISION UD06644B