HIMA HIMatrix F2 DO 16 01

To Next Page

To Previous Page

F2 DO 16 01 7 Decommissioning

HI 800 159 E Rev. 2.00 Page 31 of 40

7 Decommissioning

Remove the supply voltage to decommission the device. Afterwards pull out the pluggable

screw terminal connector blocks for inputs and outputs and the Ethernet cables.

Main Page

Table of Contents F21
Table of Contents3
Introduction5
Structure and Use of this Manual5
Table 1: Programming Tools for Himatrix Remote I/Os5
Target Audience6
Formatting Conventions7
Safety Notes7
Operating Tips8
Safety9
Intended Use9
Environmental Requirements9
ESD Protective Measures9
Table 3: Environmental Requirements9
Residual Risk10
Safety Precautions10
Emergency Information10
Product Description11
Safety Function11
Safety-Related Digital Outputs11
Figure 1: Connection of Actuators to Outputs11
Reaction in the Event of a Fault12
Equipment, Scope of Delivery13
IP Address and System ID (SRS)13
Type Label14
Figure 2: Sample Type Label14
Assembly15
Figure 3: Front View15
Figure 4: Block Diagram15
LED Indicators16
Operating Voltage LED16
System Leds16
Table 5: Operating Voltage LED16
Table 6: System Leds16
Communication Leds17
I/O Leds17
Table 7: Ethernet Indicators17
Table 8: I/O Leds17
Communication18
Connections for Ethernet Communication18
Network Ports Used for Ethernet Communication18
Figure 5: Sample MAC Address Label18
Table 9: Ethernet Interfaces Properties18
Table 10: Network Ports in Use18
Reset Key19
Product Data20
Table 11: Product Data20
Table 12: Specifications for the Digital Outputs20
Product Data F2 DO 16 01421
Certified Himatrix F2 DO 16 0121
Table 13: Product Data F2 DO 16 01421
Table 14: Certified Himatrix F2 DO 16 0121
Start-Up22
Installation and Mounting22
Connecting the Digital Outputs22
Table 15: Terminal Assignment for the Digital Outputs22
Connecting the Operating Voltage23
Cable Plugs23
Table 16: Connecting the Operating Voltage23
Table 17: Power Supply Cable Plug Properties23
Table 18: Input and Output Cable Plug Properties23
Mounting the F2 DO 16 01 in Zone 224
Figure 6: Label for Ex Conditions24
Configuration25
Configuration with Silworx25
Parameters and Error Codes for the Output25
Digital Outputs for F2 DO 16 0125
Tab Module26
Table 19: Silworx - System Parameters for Digital Outputs, Module Tab26
Tab DO 16: Channels27
Configuration with ELOP II Factory27
Configuring the Outputs27
Signals and Error Codes for the Output27
Table 20: Silworx - System Parameters for Digital Outputs, DO 16: Channels Tab27
Digital Outputs for F2 DO 16 0128
Table 21: ELOP II Factory - Digital Output System Signals28
Operation29
Handling29
Diagnosis29
Maintenance30
Faults30
Maintenance Measures30
Loading the Operating System30
Proof Test30
Decommissioning31
Transport32
Disposal33
Appendix35
Glossary35
Index of Figures36
Index of Tables37
Index38

Table of Contents

Related product manuals