HIMA HIMatrix F3 DIO 8/8 01 User Manual

F3 DIO 8/8 01 1 Introduction
HI 800 179 E Rev. 2.00 Page 5 of 52
1 Introduction
This manual describes the technical characteristics of the device and its use. It provides
information on how to install, start up and configure the module.
1.1 Structure and Use of this Manual
The content of this manual is part of the hardware description of the HIMatrix programmable
electronic system.
This manual is organized in the following main chapters:
 Introduction
 Safety
 Product Description
 Start-up
 Operation
 Maintenance
 Decommissioning
 Transport
 Disposal
HIMatrix remote I/Os are available for the programming tools SILworX and ELOP II Factory.
Which programming tool can be used, depends on the processor operating system of the
HIMatrix remote I/O, refer to the following table:
Programming tool Processor operating system
SILworX CPU OS V7 and higher
ELOP II Factory CPU OS up to V6.x
Table 1: Programming Tools for HIMatrix Remote I/Os
In the manual, the differences are specified by using:
 Separated chapters
 Tables differentiating among the versions
i
Projects created with ELOP II Factory cannot be edited with SILworX, and vice versa!
i
Compact controllers and remote I/Os are referred to as devices.

HIMA HIMatrix F3 DIO 8/8 01 Specifications

General

Brand	HIMA
Model	HIMatrix F3 DIO 8/8 01
Category	Controller
Language	English