Hioki 3284 - Page 129

39
―――――――――――――――――――――――――――
Chapter 2 Measurement Procedure
――――――――――――――――――――――――
NOTE
3. Deactivation of Recording Function
Pressing the
HOLD
key deactivates the recording
function.
HOLD
goes on,
REC
stops flashing and
goes on, and the elapsed time stops incrementing.
While the recording function is being deactivated,
data is not updated, even if the clamp sensor is
disconnected from the conductor.
Pressing the
HOLD
key again cancels
HOLD
display and activates the recording function again,
with
REC
flashing again.
4. Resetting of Recording Function
Push
0ADJ/RESET
key, in the case that data is
reset during the recording function action.
5. Cancellation of Recording Function
To cancel the recording function, press the related
function key (A or V) for the measurement in
progress. Once the recording function is canceled,
the auto power-off function becomes effective. (
APS
goes on.)
･ For a long term measurement, use the optional
9445-02 or 9445-03 AC ADAPTER, or check how
much the battery power remains by pressing
OUTPUT
.
･ When starting the recording function (REC)inan
auto range, the range is set as the range of when
that pushed
MAX/MIN
key.