Hioki BT3563A - Page 130

8.5 Message List
124
:SYSTem:CALibration:AUTO?
ON/ OFF Queries the automatic self-calibration
setting
147
Trigger Input Measured Value Ouputput
:SYSTem:DATAout
1/ 0/ ON/ OFF Sets measurement value output upon
triggering
147
:SYSTem:DATAout?
ON/ OFF Queries measurement value output
upon triggering
147
Key Beeper
:SYSTem:BEEPer:STATe
1/ 0/ ON/ OFF Sets the key beeper 148
:SYSTem:BEEPer:STATe?
ON/ OFF Queries the key beeper setting 148
Line Frequency
:SYSTem:LFRequency
AUTO/50/ 60 Selects the AC line frequency 148
:SYSTem:LFRequency?
AUTO/50/ 60 Queries the AC line frequency selec-
tion
148
Key-Lock
:SYSTem:KLOCk
1/ 0/ ON/ OFF Sets the key-lock 148
:SYSTem:KLOCk?
ON/ OFF Queries the key-lock setting 148
EXT I/O Output
:SYSTem:ELOCk
1/ 0/ ON/ OFF Sets the external input terminal lock 149
:SYSTem:ELOCk?
ON/ OFF Queries the external input terminal
lock on/off setting
149
Local
:SYSTem:LOCal
Sets local control 149
Saving and Loading Measurement Setting States
:SYSTem:SAVE
<Table No.> Saves the measurement setting state 149
:SYSTem:LOAD
<Table No.> Loads a measurement setting state 149
:SYSTem:BACKup
Backups current measurement con-
figuration
149
Header Present
:SYSTem:HEADer
1/ 0/ ON/ OFF Sets header present 150
:SYSTem:HEADer?
ON/ OFF Queries the header present setting 150
ERR Output
:SYSTem:ERRor
SYNChronous/
ASYNchronous
Sets error output timing 150
:SYSTem:ERRor?
SYNCHRONOUS/
ASYNCHRONOUS
Queries the error output timing setting 150
EOM Output
:SYSTem:EOM:MODE
<HOLD/PULSe> Selects the EOM output mode
151
:SYSTem:EOM:MODE?
(<HOLD/PULSE>) Queries the EOM output mode setting
151
Message ([ ] = optional) Data Contents
( ) = response data
Description Ref
page
HIOKI BT3562A981-09