Hioki BT3563A - Averaging Function

4.4 Averaging Function
63
4
Chapter 4 Applied Measurement
The Averaging Function averages measurement values for output. This function can minimize instability of
displayed values. The number of samples to average can be set from 2 to 16.
4.4 Averaging Function
1
(The SHIFT indicator lights up.)
The Averaging Function setting display appears.
2
Select ON.
3
The number of samples to average setting blinks.
4
Select the number of samples to average.
5
The Average Measurement display appears. (AVG lit)
To cancel the settings:
SHIFT key
(Main Display)
(Sub Display)
The current setting blinks.
(Sub Display)
Or
numeric keypads
Disabling the Averaging Function
1
(The SHIFT indicator lights up.)
The Averaging Function setting display appears.
2
Select OFF.
3
The Averaging Function is disabled. (AVG not lit)
(Sub Display)
When the internal trigger is used for continuous measurement (free-run), the
display shows the moving average. Otherwise, the display shows the integrat-
ing average.
See "4.2 Trigger Function" (p.59).
HIOKI BT3562A981-09