26
Part Names and Functions; Screens
Left side
33 442211
Right side
55 66 77 88
11
No. Name Functionality See
11
Air vents Provides ventilation to keep the instrument from
reaching too high an internal temperature.
p. 9
22
External control terminals* Allows you to control the instrument using external
signals.
Outputs alarm signals.
p. 65
33
Cable hook Pass the Z1014 AC Adapter’s cable through this hook
to keep it from being pulled out.
p. 47
44
Power inlet Connect the included Z1014 AC Adapter here.
You can externally supply power (10 V to 30 V DC)
here.
p. 46
p. 48
55
USB cable connector Connect the included USB cable here.
(USB 2.0 Mini B)
Instruction
Manual
66
USB connector Connect a USB Drive or keyboard here.
(USB 2.0 Type A)
p. 71
77
LAN connector Connect a LAN cable here.
(100Base-TX/1000Base-T)
Instruction
Manual
88
SD card slot Insert an optional SD Memory Card here.
p. 70
*: How to check the pin assignments of the external control terminals
Press the QUICK SET key, and choose [External control terminal connection guide]. Names of the
external control terminals will be displayed.
Function name Pin number Signal name See
Pulse input 5, 6, 7, 8, 10, 11, 12, 13 PULSE 1 to PULSE 8 p. 61
Warning output 22, 23, 24, 25, 27, 28, 29,
30
ALARM 1 to ALARM 8 p. 62
Voltage output 2, 3 V OUTPUT 1
V OUTPUT 2
p. 63
External control 19, 20, 32, 33 I/O 1 to I/O 4 p. 65
GND 1, 4, 9, 14,17, 18, 21, 26,
31, 34
GND –
(Reserved) 15, 16 SYNC.IN, SYNC.OUT –
See “8 External Control (Ext. I/O)” in the Instruction Manual.
To Next Page
Loading...
Need help?
General
