3.4 Viewing Harmonic Measured Values
75
Harmonic voltage content percentage (HRM V %), harmonic current content percentage (HRM A %), har-
monic active power content percentage (HRM W %)
Display method
Harmonic voltage phase angle, harmonic current phase angle, harmonic voltage/current phase difference
These parameters cannot be displayed. They can only be downloaded using communications functionality.
(See the Communications Command Instruction Manual.)
Parameters displayed as harmonic content percentage (HD %)
1 Press to display HD %.
2 Press , , or to
change the harmonic order.
After pressing or :
01 (1st order: fundamental wave compo-
nent) → 02 (2nd order) → … → 49 (49th
order) → 50 (50th order) → 00 (0th order:
DC component) → 01
After pressing or
01
→ 00 → 50 → 49 → ⋅⋅⋅ → 02 → 01
3 The harmonic content percentage
will be displayed in areas
through on the display.
(Default display)
Display area b: CH1 harmonic voltage content
percentage
Display area c: CH1 harmonic current content
percentage
Display area d: Harmonic active power content
percentage
4 Press to change the channel
being shown.
5 Press through to change
the display parameter.
Parameters that can be downloaded with communications functionality
To Next Page
Loading...
