Hirschmann HiSecOS EAGLE20 - Packet Filter Rule

Network Security > Packet Filter > Rule
Network Security
144
RM GUI HiSecOS EAGLE20/30
Release 3.0 09/2015
Network Security > Packet Filter > Rule
4.5 Packet Filter Rule
This dialog allows you to configure rules for the packet filter. You assign the
rules specified here to the desired ports in the
Network Security > Packet
Filter > Assignment
dialog.
 Table
Parameters Meaning
Rule Index Displays the sequential number of the rule. The device automatically
assigns this number.
Description Specifies a name or description for the rule.
Possible values:
 alphanumerical ASCII string with 0..64 characters
Source Address Specifies the source address of the data packets to which the device
applies the rule.
Possible values:
 any (default setting)
The device applies the rule to data packets with any source address.
 Valid IPv4 address
The device applies the rule to data packets with the specified source
address.
 Valid IPv4 address and netmask in CIDR notation
The device applies the rule to data packets with the specified source
address in the specified subnet.
 An exclamation mark ( ! ) preceding the IP address reverses the
expression into its opposite. The device applies the rule to data
packets which do not contain the source address specified here.