Hirschmann HiSecOS EAGLE20 - ACL Ipv4 Rule

Network Security > ACL > IPv4 Rule
Network Security
186
RM GUI HiSecOS EAGLE20/30
Release 3.0 09/2015
Network Security > ACL > IPv4 Rule
4.18 ACL IPv4 Rule
In this dialog, you specify the rules that the device applies to the IP data
packets.
An Access Control List (group) contains one or more rules. The device
applies the rules of an Access Control List successively, beginning with the
rule with the lowest value in the "Index" column.
The device allows you to filter according to the following criteria:
 Source or destination IP address of a data packet
 Type of the transmitting protocol
 Source or destination port of a data packet
 Classification according to DSCP
 Classification according to ToS
 Table
Parameters Meaning
Group Name Displays the name of the Access Control List. The Access Control List
contains the rules.
Index Displays the number of the rule within the Access Control List.
If the Access Control List contains multiple rules, the device processes the
rule with the lowest value first.
Active Activates/deactivates the Access Control List or the rule within an Access
Control List.
Possible values (for an Access Control List):
 marked (default setting)
The Access Control List is active. The device applies the associated
active rules to the data stream.
 unmarked
The Access Control List is inactive.
Possible values (for rules within an Access Control List):
 marked (default setting)
The rule is active. The device applies the rule to the data stream if the
associated Access Control List is also active.
 unmarked
The rule is inactive.