Hirschmann HiSecOS EAGLE20 - 1.7 Restart

Basic Settings > Restart
Basic Settings
RM GUI HiSecOS EAGLE20/30
Release 3.0 09/2015
65
Basic Settings > Restart
1.7 Restart
This dialog allows you to restart the device, reset port counters and address
tables, and delete log files.
 Restart
 Buttons
Parameters Meaning
Cold start... Opens the "Restart" dialog to initiate a restart of the device.
If the configuration profile in the volatile memory (
RAM ) and the Selected
configuration profile in the non-volatile memory (
NVM ) differ, the device
displays the "Warning" dialog.
 To permanently save the changes, click the "Yes" button in the
"Warning" dialog.
 To discard the changes, click "No" in the "Warning" dialog.
The device restarts and goes through the following phases:
 The device performs a RAM test if this function is activated in the
Diagnostics > System > Selftest dialog.
 The device starts the device software that the "Stored Version" field
displays in the
Basic Settings > Software dialog.
 The device loads the settings from the Selected configuration profile,
see
Basic Settings > Load/Save dialog.
Note: During the restart, the device does not transfer any data. During this
time, the device cannot be accessed by the graphical user interface or
other management systems.
Button Meaning
Reset MAC
Address Table
Removes the MAC addresses from the forwarding table that have in the
Switching > Filter for MAC Addresses dialog the value learned in the
"Status" column.
Reset ARP Table Removes the dynamically set up addresses from the ARP table - see the
Diagnostics > System > ARP Table dialog.
Clear Port Statistics Resets the counter for the port statistics to
0 - see the Basic Settings >
Port dialog, "Statistics" tab.
Delete Log File Removes the logged events from the log file - see the
Diagnostics >
Report > System Log dialog.