Hirschmann HiSecOS EAGLE20 - Configuration

Routing > Interfaces > Configuration
Routing
280
RM GUI HiSecOS EAGLE20/30
Release 3.0 09/2015
Routing > Interfaces > Configuration
8.3 Configuration
This dialog allows you to specify the settings for the router interfaces.
To set up a port-based router interface, edit the table entries. To set up a
VLAN-based router interface, use the Wizard.
 Table
Parameters Meaning
Port Displays the number of the port or VLAN belonging to the router interface.
Name Name of the device port.
Enter the name of your choice.
Possible values:
 alphanumeric ASCII character string with 0..64 characters
Port on Activates/deactivates the port.
Possible values:
 marked (default setting)
The port is active.
 unmarked
The port is inactive. The port does not send or receive any data.
Port Status Displays the operating state of the port.
Possible values:
 marked
The port is enabled.
 unmarked
The port is disabled.
IP Address Specifies the IP address for the router interface.
Possible values:
 Valid IPv4 address (default setting: 0.0.0.0 )
Netmask Specifies the network mask for the router interface.
Possible values:
 Valid IPv4 netmask (default setting: 0.0.0.0 )