Network Security > Packet Filter > Rule
Network Security
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
149
Buttons
DPI Profile Index Displays which "Modbus Enforcer" or "OPC Enforcer" rule the device
applies to the data packets.
The column is only available in the
?
variant - see the
Software Level
characteristic value in the product code.
The prerequisite for changing the value is that you specify the value
enforce-modbus
or enforce-modbus in the "Action" column and click the
"Set" button.
Possible values:
0
(default setting)
The device does not apply any rule to the data packets.
1..32
When you click the field, a drop-down list opens. Select a value from
the drop-down list.
– If the
enforce-modbus
value is specified in the "Action" column,
see the "Index" and "Description" fields of the rules specified in the
Network Security > DPI > Modbus Enforcer
dialog.
– If the
enforce-opc
value is specified in the "Action" column, see
the "Index" and "Description" fields of the rules specified in the
Network Security > DPI > OPC Enforcer
dialog.
To apply changes to the data stream, click the "Set" button.
Active Activates/deactivates the rule.
Possible values:
marked
(default setting)
The rule is active.
unmarked
The rule is inactive.
Button Meaning
Set Transfers the changes to the volatile memory (
RAM
) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
Open the
Basic Settings > Load/Save
dialog.
In the table, highlight the desired configuration profile.
If in the "Selected" column the checkbox is
unmarked
, click the
"Select" button.
Click the "Save" button.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM
) of the device.
Create Adds a new table entry.
Remove Removes the highlighted table entry.
Help Opens the online help.
Parameters Meaning
To Next Page
Loading...