Hirschmann HiSecOS EAGLE20 - Page 153

Network Security > Packet Filter > Assignment
Network Security
RM GUI HiSecOS EAGLE20/30
Release 3.0 09/2015
153
 Buttons
Button Meaning
Set Transfers the changes to the volatile memory (
RAM ) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
 Open the
Basic Settings > Load/Save dialog.
 In the table, highlight the desired configuration profile.
 If in the "Selected" column the checkbox is
unmarked , click the
"Select" button.
 Click the "Save" button.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM ) of the device.
Assign Opens the "Assign" dialog to assign a rule to a routing interface.
 In the "Interface" field, you specify the routing interface to which the
device applies the rule.
 In the "Direction" field, you specify the data packets to which the
device applies the rule.
 In the "Rule Index" field, you specify rule which you assign to the
routing interface.
Remove Removes the highlighted table entry.
Commit Changes Applies the rules saved in the device to the data stream.
In the process, the device also removes the state information from the
packet filter. This includes potential DCE RPC information of the OPC
enforcer. In the process, the device interrupts open communication
connections.
Note: While the device is activating the saved rules, the establishment of
any new communication connections is impossible.
Help Opens the online help.