Hirschmann HiSecOS EAGLE20 - Page 25

Graphical User Interface
RM GUI HiSecOS EAGLE20/30
Release 3.0 09/2015
25
Displays the time in seconds after which the device automatically ends the
session when the user is inactive.
You specify the timeout period in the
Device Security > Management Access >
Web dialog.
Displays that the configuration profile in the volatile memory (
RAM ) differs from the
"Selected" configuration profile in the permanent memory (
NVM ). Save the current
device settings permanently so that they are available to you after a restart.
To permanently save the changes, proceed as follows:
 Open the
Basic Settings > Load/Save dialog.
 In the table, highlight the desired configuration profile.
 If in the "Selected" column the checkbox is
unmarked , click the "Select"
button.
 Click the "Save" button.
The device automatically compares the configuration profiles once a minute. To
update the display manually, click the button. If the configuration profiles
match, the button is hidden.
By right-clicking this symbol you have the option of opening the
Basic
Settings > Load/Save
dialog directly.
When you position the mouse pointer over the button, the user interface opens
a bubble help with the following information:
 The "Last Update" section displays the time at which the device last
refreshed the values.
 The "Device Status" section displays a compressed view of the "Device
Status" frame in the
Basic Settings > System dialog. The section displays
the alarm that is currently active and whose occurrence was recorded first.
 The "Boot Parameter" section displays a note if you permanently save
changes to the settings and at least one boot parameter differs from the
configuration profile used during the last restart.
The following settings cause the boot parameters to change:
–
Basic Settings > External Memory dialog, "Enable Automatic Software
Update" parameter
–
Device Security > Management Access > Server dialog, "SNMP" tab,
"UDP Port" parameter
–
Diagnostics > System > Selftest dialog, "Activate SysMon1"
parameter
–
Diagnostics > System > Selftest dialog, "Load default config on error"
parameter
Button Meaning
Table 4: Buttons in the status line (cont.)