Switching > VLAN > Configuration
Switching
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
261
Buttons
Name Specifies the name of the VLAN.
Possible values:
alphanumeric ASCII character string with 1..32 characters
<Port number> Specifies if the respective port transmits data packets of the VLAN and if the
data packets contain a VLAN tag.
Possible values:
-
(default setting)
The port is not a member of the VLAN and does not transmit data
packets of the VLAN.
T
= Tagged
The port is a member of the VLAN and transmits the data packets with
a VLAN tag. You use this setting for uplink ports, for example.
F
= Forbidden
The port is not a member of the VLAN and does not transmit data
packets of this VLAN.
U
= Untagged (default setting for VLAN 1)
The port is a member of the VLAN and transmits the data packets
without a VLAN tag. Use this setting if the connected device does not
evaluate any VLAN tags, for example on end device ports.
Note: Verify that the port on which the network management station is
connected is a member of the VLAN in which the device transmits the
management data. In the default setting, the device transmits the
management data on VLAN 1. Otherwise, the connection to the device
terminates when you transfer the changes to the device. To access the
management functions is possible solely using the CLI through the V.24
interface of the device.
Button Meaning
Set Transfers the changes to the volatile memory (
RAM
) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
Open the
Basic Settings > Load/Save
dialog.
In the table, highlight the desired configuration profile.
If in the "Selected" column the checkbox is
unmarked
, click the
"Select" button.
Click the "Save" button.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM
) of the device.
Create Opens the "Create" dialog to add a new entry to the table.
In the "VLAN ID" field, you specify the ID of the VLAN.
Parameters Meaning
To Next Page
Loading...