Hirschmann HiSecOS EAGLE20 - Page 38

Basic Settings > Network
Basic Settings
38
RM GUI HiSecOS EAGLE20/30
Release 3.0 09/2015
 IP Parameter
This frame allows you to assign the IP parameters manually. These fields
can be edited if you have selected the value
Local in the "Management
Interface" frame, "IP Address Assignment" field.
 Buttons
Parameters Meaning
IP Address Specifies the IP address under which the device management can be
accessed through the network.
Possible values:
 Valid IPv4 address
(default setting: —)
Netmask Specifies the netmask.
The netmask identifies the network prefix and the host address of the
device in the IP address.
Possible values:
 Valid IPv4 netmask
(default setting: —)
Gateway address Specifies the IP address of a router through which the device accesses
other devices outside its own network.
Possible values:
 Valid IPv4 address
(default setting: —)
Button Meaning
Set Transfers the changes to the volatile memory (
RAM ) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
 Open the
Basic Settings > Load/Save dialog.
 In the table, highlight the desired configuration profile.
 If in the "Selected" column the checkbox is
unmarked , click the
"Select" button.
 Click the "Save" button.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM ) of the device.
Help Opens the online help.