Hirschmann HiSecOS EAGLE20 - Page 450

Diagnostics > System > Selftest
Diagnostics
450
RM GUI HiSecOS EAGLE20/30
Release 3.0 09/2015
 Table
In this table you specify how the device behaves in the case of an error.
 Buttons
Parameters Meaning
Cause Error causes to which the device reacts.
Possible values:
 task
The device detects errors in the applications executed, e.g. if a task
terminates or is not available.
 resource
The device detects errors in the resources available, e.g. if the
memory is becoming scarce.
 software
The device detects software errors, e.g. error in the consistency
check.
 hardware
The device detects hardware errors, e.g. in the chip set.
Action Specifies how the device behaves if the adjacent event occurs.
Possible values:
 reboot (default setting)
The device triggers a restart.
 logOnly
The device registers the detected error in the log file (system log).
 sendTrap
The device sends a SNMP trap.
The prerequisite for sending SNMP traps is that you enable the function in
the
Diagnostics > Status Configuration > Alarms (Traps) dialog and
specify at least 1 SNMP manager.
Button Meaning
Set Transfers the changes to the volatile memory (
RAM ) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
 Open the
Basic Settings > Load/Save dialog.
 In the table, highlight the desired configuration profile.
 If in the "Selected" column the checkbox is
unmarked , click the
"Select" button.
 Click the "Save" button.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM ) of the device.
Help Opens the online help.