Device Security > Authentication List
Device Security
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
87
Note: If the table does not contain a list, the access to the management
functions is possible using CLI through the V.24 interface of the device
exclusively. In this case, the device authenticates the user by using the
local user management, see the
Device Security > User Management
dialog.
Buttons
Dedicated
Applications
Displays the dedicated applications. When users access the device with
the relevant application, the device uses the specified policies for the
authentication.
To allocate another application to the list or remove the allocation, click the
"Allocate Applications" button. Allocate one application solely to one list.
Active Activates/deactivates the list.
Possible values:
marked
The list is activated. The device uses the policies in this list when
users access the device with the relevant application.
unmarked
(default setting)
The list is deactivated.
Button Meaning
Set Transfers the changes to the volatile memory (
RAM
) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
Open the
Basic Settings > Load/Save
dialog.
In the table, highlight the desired configuration profile.
If in the "Selected" column the checkbox is
unmarked
, click the
"Select" button.
Click the "Save" button.
Set and back Transfers the changes to the volatile memory (
RAM
) of the device and goes
back to the previous dialog.
Back Displays the previous dialog again. Changes are lost.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM
) of the device.
Remove Removes the highlighted table entry.
Create Adds a new table entry.
Parameters Meaning
To Next Page
Loading...