Installation MS20/MS30
Release
11
07/2013
31
2 Assembly and start-up
The devices have been developed for practical application in a harsh
industrial environment.
Hirschmann supplies the device ready for operation.
The following steps should be performed to install and configure a device:
Unpacking and checking
Installing the media modules
Filling out and attaching labels
Installing the SFP transceivers (optional)
Adjusting the DIP switch settings on the basic module (4-pin DIP switch)
Adjusting the DIP switch settings on the MS20/MS30-...E... basic module
(3-pin DIP switch)
Adjusting the DIP switch settings on the MM20-A8A89999SAHH media
module
Connecting the MM22-T1T1T1T1 PoE media module
Terminal block for supply voltage and signal contact
Connecting the terminal blocks, start-up procedure
Installing the device on the DIN rail, grounding
Connecting the data lines
Assembly of the MB20 extender module
Defining the meaning of the display LEDs
2.1 Unpacking and checking
Check whether the package includes all items named in section “Scope
of delivery” on page 66.
Check the individual parts for transport damage.
To Next Page
Loading...
Need help?
General
