Installation MS20/MS30
Release
11
07/2013
47
2.13 Assembly of the MB20 extender module
The MB20 extender module allows you to expand the MS20-1600 and
MS30-1602 basic module with two sockets for media modules. You can
install the MB20 extender module in running operation.
On the right side of the basic module, loosen the screws at the top and
bottom (1-3 revolutions).
Take off the side panel.
If you have not already done so, mount the basic module on the DIN rail.
Push the MB20 extender module on the DIN rail to the basic module until
the modules are plugged together.
Tighten the screws on the top and bottom of the basic module again.
2.14 Defining the meaning of the display LEDs
You use the "SELECT" button on the basic module to define the meaning of
the LEDs of the media modules. You press the button to switch to the next
display meaning. The display status LEDs of the basic module show the
current meaning of the port LEDs of the media modules.
See “Display elements” on page 26.
Figure 20: "SELECT" button on the MICE basic modules
1 - Display LEDs
2 - “SELECT” key
To Next Page
Loading...
Need help?
General
