Hirschmann Octopus II - Page 10

10
Installation Octopus II
Release 06 10/2018
Regulation No. 10 of the Economic Commission for Europe of the United
Nations (UN/ECE): Devices with an approval are labeled with the
E type approval mark.
For devices labeled with the E type-approval mark, the following
installation conditions apply:
 The entire 24 V power supply network must be installed up to the
battery with shielded power supply cables.
 The shield must be grounded near the battery.
 CE marking
The labeled devices comply with the regulations contained in the following
European directive(s):
In accordance with the above-named EU directive(s), the EU conformity
declaration will be at the disposal of the relevant authorities at the
following address:
Hirschmann Automation and Control GmbH
Stuttgarter Str. 45-51
72654 Neckartenzlingen
Germany
www.hirschmann.com
The product can be used in the industrial sector.
 Interference immunity: EN 61000-6-2
 Emitted interference: EN 55032
 Reliability: EN 60950-1
You find more information on technical standards here:
“Technical data” on page 49
Device variant Directive
All variants 2014/30/EU (EMC)
Directive of the European Parliament and the council for
standardizing the regulations of member states with regard to
electromagnetic compatibility.
2011/65/EU (RoHS)
Directive of the European Parliament and of the Council on the
restriction of the use of certain hazardous substances in
electrical and electronic equipment.
Exclusively for device variants
featuring supply voltage with
characteristic value M9 or N9:
2014/35/EU
Directive of the European Parliament and of the Council on the
harmonisation of the laws of the Member States relating to the
making available on the market of electrical equipment
designed for use within certain voltage limits.