Hirschmann Octopus II - Signal Contact; Operating the Device

Installation Octopus II
Release 06 10/2018
43
2.4.8 Signal contact
A 5-pin M12 plug is available as a signal contact.
You find the prescribed tightening torque in chapter:
See “Technical data” on page 49.
Depending on device variant, the signal contact lines are laid in the power
supply plug or in a separate plug.
2.5 Operating the device
By connecting the supply voltage via a connector, you start the operation of
the device.
Pin assignments for device
variants:
 Supply voltage with the
characteristic value BB
 Supply voltage with the
characteristic value HH
Pin assignments for device
variants:
 Supply voltage with
characteristic value FF
 Supply voltage with the
characteristic value M9
 Supply voltage with the
characteristic value N9
 Supply voltage with
characteristic value QQ
 Supply voltage with the
characteristic value PP
1 Plus terminal of supply voltage 1 N.C.
2 Signal contact Signal contact
3 Minus terminal of supply voltages
1 and 2
N.C.
4 Plus terminal of supply voltage 2 N.C.
5 Signal contact Signal contact
WARNING
ELECTRIC SHOCK
Before connecting the electrical wires, always verify that the requirements
listed are complied with.
See “Requirements for connecting electrical wires” on page 6.
Failure to follow this instruction can result in death, serious injury, or
equipment damage.