Hirschmann Octopus II - Interface (External Management)

32
Installation Octopus II
Release 06 10/2018
1.7.2 V.24 interface (external management)
The V.24 interface is an M12 socket.
A serial interface is provided on the V.24 interface for the local connection of
an external management station (VT100 terminal or PC with corresponding
terminal emulation). This enables you to set up a connection to the
Command Line Interface (CLI) and to the system monitor.
The socket housing is electrically connected to the housing of the device.
Figure 1: Terminal cable for connecting an external Management Station
Pin Function
1U
in
5 V
2 N.C. Not used
3 D- Data -
4 GND Ground (0 V)
5 D+ Data +
Table 13: Pin assignment of the USB interface, 5-pin, “A”-coded M12 socket
VT100 terminal settings
Speed 9600 Baud
Data 8 bit
Stopbit 1 bit
Handshake off
Parity none
Figure Pin Function
1 TX. Transmit Data
2 RX Receive Data
3 N.C. Not used
4 GND Ground
Table 14: Pin assignment of the V.24 interface (M12 socket)
5
M12 M12
DB9 DB9
2
3
5
1
2
3
4
1
2
3
4
6
7
8
9