Hirschmann Octopus II - 1.7 Management interfaces

Installation Octopus II
Release 06 10/2018
31
1.6.2 Port status
These LEDs provide port-related information.
 Link state
These LEDs are identified with the number of the related port.
 PoE status
Only PoE ports have these LEDs. The LED is on the right of the respective
link state LED.
1.7 Management interfaces
1.7.1 USB interface
This interface offers you the ability to connect the storage medium
AutoConfiguration Adapter ACA21-M12/ACA22-M12. This storage medium
is used for saving/loading the configuration and diagnostic functions, and for
loading the software.
This interface is a 5-pin, “A”-coded M12 socket with shielding.
Only connect the ACA21-M12/ACA22-M12 storage medium. You can obtain
this as accessory: See “Accessories” on page 62.
LED Display Color Activity Meaning
L/D Link status — none Device detects an invalid or missing
link
green lights up Device detects a valid link
flashes 1 time a period Port is switched to stand-by
flashes 3 times a period Port is switched off
yellow lights up Device detects a data rate that is not
supported
flashing Device is transmitting and/or receiving
data
flashes 1 time a period Device detects at least one
unauthorized MAC address (Port
Security Violation)
LED Display Color Activity Meaning
PoE PoE status — none No powered device connected
green lights up Powered device is supplied with PoE
voltage.
yellow flashes 1 time a period Output budget has been exceeded
Device has detected a connected
powered device
flashes 3 times a period PoE administrator status deactivated