26
Installation Octopus II
Release
06
10/2018
10/100/1000 Mbit/s twisted pair port
Note: Some of these ports also support PoE(+).
See “Support of PoE(+)” on page 26.
This port is an 8-pin, “X”-coded M12 socket.
The 10/100/1000 Mbit/s twisted pair port allows you to connect network
components according to the IEEE 802.3 10BASE-T/100BASE-TX/
1000BASE-T standard.
This port supports:
Autocrossing
Autonegotiation
Autopolarity
10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode
1000 Mbit/s full duplex
Delivery state: Autonegotiation activated
The socket housing is electrically connected with the device housing.
1.5.2 Support of PoE(+)
The device variants featuring hardware type characteristic value 4 support
Power over Ethernet (PoE) and Power over Ethernet Plus (PoE+).
With the presence of the PoE power supply, a separate power supply for the
connected device is unnecessary.
You can identify PoE(+) ports by the following symbol.
The individual ports (joint PoE voltage) are not electrically insulated from
each other.
Maximum power available to PoE end devices in total:
60 W
Note: For device variants with supply voltage characteristic value PP, use an
external PoE power supply unit with 150 W. This means that the maximum
output available to all PoE end devices is in total 120 W.
Connect only PoE-supplier devices whose data connections are located in
the interior of the building and are specified as SELV circuits.
To Next Page
Loading...
