Hirschmann Octopus II - 1.5 Ethernet ports

Installation Octopus II
Release 06 10/2018
25
“Supply voltage with the characteristic value QQ” on page 41
These device variants support PoE(+).
Further information:
“Support of PoE(+)” on page 26
1.4.7 Supply voltage with the characteristic value PP
A 4-pin, “T”-coded M12 power plug is available for the redundant supply of
the device.
These device variants support PoE(+).
Further information:
“Supply voltage with the characteristic value PP” on page 41
1.5 Ethernet ports
You have the option of choosing various media to connect to the end devices
and other network components:
 Multimode optical fiber
 Singlemode optical fiber
 Twisted pair cable
You find information on pin assignments for making patch cables here:
“Pin assignments” on page 29
1.5.1 Twisted pair
 10/100 Mbit/s twisted pair port
Note: Some of these ports also support PoE(+).
See “Support of PoE(+)” on page 26.
This port is a 4-pin, “D”-coded M12 socket.
The 10/100 Mbit/s twisted pair port allows you to connect network
components according to the IEEE 802.3 10BASE-T/100BASE-TX
standard.
This port supports:
 Autonegotiation
 Autopolarity
 Autocrossing (if autonegotiation is activated)
 100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode
 10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
Delivery state: Autonegotiation activated
The socket housing is electrically connected with the device housing.