28
Installation RSP 20/25/30/35
Release
15
12/2017
Applies to software releases after 02.0.00:
1.6.2 Port status
These LEDs provide port-related information.
The LEDs are directly located on the ports.
Applies to software releases before 02.0.00:
Applies to software releases after 02.0.00:
LED Display Color Activity Meaning
Status Device Status — none Device is starting and/or is not ready for
operation
green Lights up Device is ready for operation.
Characteristics can be configured
red Lights up Device is ready for operation.
Device has detected at least one error in
the monitoring results
Flashes 1 time
a period
The boot parameters used when the
device has been started differ from the
boot parameters saved.
Start the device again.
flashes 4 times
a period
Device has detected a multiple IP address
Display Color Activity Meaning
Link status — none Device detects an invalid or missing link
green Lights up Device detects a valid link
Flashes 1 time a period Port is switched to stand-by
Flashes 3 times a period Port is switched off
yellow Flashing Device is transmitting and/or receiving data
Display Color Activity Meaning
Link status — none Device detects an invalid or missing link
green Lights up Device detects a valid link
Flashes 1 time a period Port is switched to stand-by
Flashes 3 times a period Port is switched off
yellow Lights up Device detects a non-supported SFP
transceiver or a non-supported data rate
Flashing Device is transmitting and/or receiving data
Flashes 1 time a period Device detects at least one unauthorized
MAC address (Port Security Violation)
To Next Page
Loading...
Need help?
General
