Installation RSP 20/25/30/35
Release
15
12/2017
43
3 Making basic settings
The IP parameters must be entered when the device is installed for the first
time. The device provides the following options for configuring IP addresses:
Input via the V.24 interface
Entry via the HiDiscovery protocol in the applications HiDiscovery or
Industrial HiVision
Configuration via BOOTP
Configuration via DHCP (Option 82)
AutoConfiguration Adapter
Default settings
IP address: The device looks for the IP address using DHCP
Management password:
user, password: public (read only)
admin, password: private (read/write)
V.24 data rate: 9600 Baud
Ethernet ports: link status is not evaluated (signal contact)
Optical ports: Full duplex
TP ports: Autonegotiation
RSTP (Rapid Spanning Tree) activated
To Next Page
Loading...
Need help?
General
