Hisun AXIS 110 - Page 89

Periodic Maintenance and Adjustment 8-27
needed
2
Display is abnormal on
the display panel
1. Check speed sensor for damage. Replace if needed
2. Check display panel for damage. Replace if needed
3. Check surface of speed sensor for oxidation. Replace if needed
3
Shutdown switch does
not turn off the engine.
1. Check to see if the shutdown switch has a problem. Replaced if
needed
2. Check wires for damage. Replace or repair wire if needed
3. Check to see if the ECU or the EFI systems is damaged. Have a
service center repair if needed
Sheet 4: Operational troubleshooting
S/N
Problems
Solutions
1
Steering is loose
1. Check to see if the nuts on the steering column, steering knuckles and
steering stem are loose. Tighten if necessary.
2. Check steering column for damage.
3. Inspect tie rods for looseness or damage. Replace if needed
2
Front wheels shake when
driving.
1. Inspect tie rods for looseness or damage. Replace if needed
2. Check lug nuts on front wheels for looseness. Tighten if needed.
3. Inspect bearings in the front wheel hub for damage or excessive wear.
Replace bearings if necessary,