Hisun AXIS 110 - Engine Troubleshooting

8-28 Periodic Maintenance and Adjustment
4. Check all rubber bushings for damage in front end assembly.
Replace if needed.
3
Rear wheels shake while
driving
1. Check bearings in the rear axle assembly for damage. Replace if
needed
2. Check swing arm bearing for damage. Replace if needed
3. Check retainer nuts holding rear wheels on for looseness or damage.
4. Check internal splines of rear wheel hub and outer splines of rear axle
for excessive wear or damage. Replace axle or wheel hub if needed.
5. Check all rubber bushings for damage in rear end assembly.
Replace if needed.
Sheet 5: Engine troubleshooting
S/N
Problems
Solutions
1
Engine will not start
1. Make sure key and emergency shut off switch are at the “ON” position.
2. Check fuel level
3. Check to make sure spark plug is secure and that the spark plug cap is
attached.
4. Inspect electrical circuits. A service center can perform this
diagnostic.
2
Engine idle cannot be
adjusted using computer
1. Inspect throttle cable, make sure it is not sticking
2. Check to see if the ECU is damaged. Service center can diagnose.
3
Idle Unstable
1. Check battery with voltage meter, if voltage is lower than the specified