Table 2-113 Action button at the bottom
Item Description
OK Takes effect the LPAR manager initial settings.
Cancel Cancels the settings and returns to the LP Settings dialog box.
Back button Returns to the LP Settings (Editing) dialog box.
• LPAR Information
LPAR Information dialog box is shown by clicking an LPAR name in LPAR
tab in the case that an LPAR manager is running.
Table 2-114 Items in LPAR information
Item Description
LPAR Status
1
LPAR State Shows a state of the LPAR.
LP firmware Shows the LPAR manager firmware version.
(Show the minor version in [] brackets.)
LPAR
Settings
2
Name Shows the LPAR name.
Processor Shows the number of logical processors assigned to
the LPAR. Shows a scheduling mode of the logical
processor: shared or dedicated.
Memory Shows an amount of memory to assign to the LPAR.
HBA Number Shows a card type, controller number, scheduling
mode, port number, vfcID, World Wide Node Name,
World Wide Port Name, and Enable or Disable for
boot function.
[Management module firmware version A0205 or
later]
Operating the Web Console
2-105
Hitachi Compute Blade 500 Series Web Console User's Guide
To Next Page
Loading...
