Item Description
Shows the number of a server blade in which the card
is installed and the card type in SMP configuration.
Shows boot settings for the HBA port by clicking
Enable or Disable for the boot function.
NIC Number Shows a card type, controller number, scheduling
mode, port number, segment number, virtual NIC
number, and MAC address.
[Management module firmware version A0205 or
later]
Shows the number of a server blade in which the card
is installed and the card type in SMP configuration.
USB Number [Management module firmware version A0205 or
later]
Shows the port type and operation status.
Shows the number of a server blade in which USB is
installed and the port type in SMP configuration.
Boot Mode [Management module firmware version A0205 or
later]
Shows the boot mode for the LPAR.
Note:
1. Shows the LPAR status.
2. Shows the LPAR settings.
Table 2-115 Action button at the bottom
Item Description
Activate [Management module firmware version A0125 or later]
Activates the LPAR: Shows the confirmation dialog box. This button is
available when the LPAR is deactivated: LPAR state is DEACT.
Boot order
settings
[Management module firmware version A0125 or later]
Shows LPAR boot order dialog box. This button is available when the
LPAR is deactivated: LPAR state is DEACT.
Modify LPAR Modifies LPAR settings. This button is available when the LPAR is
deactivated: LPAR state is DEACT.
Close Closes the LPAR Information dialog box.
• Modify LPAR
2-106
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide
To Next Page
Loading...
