Item Description
The setting for the "Switch and management module's IP
address", which is set by the HA monitor environment setup
(monsetup) command, must be "auto".
Disable: Does not perform a system failover in the N+M cold
standby configuration.
Table 2-198 Action button at the bottom
Item Description
Edit Edits the HA monitor settings.
Firmware
This window shows server blade firmware and LPAR manager firmware
versions. You can update them on this window. Multiple server blade
firmware versions can be updated at a time.
See Hitachi Compute Blade 500 Series Management Module Setup Guide
for
details.
Server blade tab
2-170
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide
To Next Page
Loading...
