Item Description
ON: The LID (Identification LED) turns on.
OFF: the LID (Identification LED) turns off.
-----: No server bladed is installed.
Status Shows an operation state of the server blade among the following
states.
Normal: In normal state.
Warning: In warning state. See the event log list to check details.
Failed: In failed condition. See the event log list to check details.
-----: No server bladed is installed.
Maintenance
mode
Shows the server blade mode.
ON: Set in maintenance mode.
OFF: Not set in maintenance mode.
Remaining time
[min]
When a server blade is in maintenance mode, the remaining time for
the mode is shown in minutes.
Logical
Partitioning
Shows an OS operation mode.
Disabled: OS in Basic mode, not in LP mode, starts.
Enabled: OS in LP mode starts.
-----: No server bladed is installed or a non-primary server blade is
installed.
Table 2-23 Action buttons at the bottom
Item Description
Smart
Configure
Performs Smart Configure to the selected server blade. You can specify
multiple server blades for Smart Configure.
Start Remote
Console
Starts the remote console of the selected server blade. The remote
console appears on another window. You can select multiple server
blades for this item.
LID ON Turns on the LID (Identification LED) of the selected server blade. You
can select multiple server blades to turn on their LIDs.
LID OFF Turns off the LID (Identification LED) of the selected server blade. You
can select multiple server blades to turn off their LIDs.
Power ON Powers on the selected server blade. You can select multiple server
blades to power on.
Power OFF Shuts down the selected server blade to be powered off. You can select
multiple server blades to shut down. Some running OSs may not be
powered off due to the OS settings. Check the OS settings before using
this item.
2-26
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide
To Next Page
Loading...
