Item Description
Configured: Smart Configure is completed.
Not Configured: Neither a newly activated server blade
nor the one for recovery starts running although N+M
cold standby switches server blades. This is a temporary
state that occurs at switching server blades with N+M
cold standby.
Server blade
firmware
version
Current
version
Shows the current server blade firmware version.
Next boot
version
Shows a server blade firmware version to be used at the
next boot. This item is shown only after the server blade
firmware is updated.
BMC version Current
version
Shows the current BMC firmware version.
Next boot
version
Shows a BMC version to be used at the next boot. This
item is shown only after the server blade firmware is
updated.
EFI version Current
version
Shows the current EFI firmware version.
Next boot
version
Shows an EFI version to be used at the next boot. This
item is shown only after the server blade firmware is
updated.
Table 2-36 Action buttons at the bottom
Item Description
LID ON Turns on the LID (Identification LED) of the selected
server blade. When no server blade is selected, the
Action button is not available.
LID OFF Turns off the LID (Identification LED) of the selected
server blade. When no server blade is selected, the
Action button is not available.
Power ON Turns on the selected server blade.
Power OFF Turns off the selected server blade. The power may
not be turned off depending on the setting of the
currently running OS. Check the OS setting when
using this item.
Server Blade
Action
Force power OFF Forcibly turns off the power to the server blade.
Cancel Power On
suppression
Cancels the power-on restriction setting for the
selected server blade. If N+M switching fails on the
way, the power-on restriction may be enabled.
Reset Resets the selected server blade hardware.
Issue NMI Issues NMI (Non-Maskable Interrupt) to the OS
running on the selected server blade.
Run Smart
Configure
Performs Smart Configure on the selected server
blade.
2-36
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide
To Next Page
Loading...
