Item Description
Authentication
method
Select an authentication method.
•
PAP
• CHAP
• MS-CHAPv2
Port number
(Authentication)
Enter the destination port number for
authentication of the RADIUS server.
Specify 1812 or a value in the range from 1 to
65535 for the port number.
Shared Secret Enter a key character string shared between BMC
and the RADIUS server.
You can enter a character string of 32 to 64
characters. The string can contain alphanumeric
characters and the following symbols: . _ $ - = +
* % ? : @ / \ ' ! ~ ; ^ ( ) [ ] { } | , `
The symbols <, >, &, #, ", and spaces cannot be
used.
Retransmit retry Enter the number of times to reconnect to the
RADIUS server if the RADIUS server does not
respond. Specify 3 time or a value in the range
from 1 to 10 times.
Timeout
period(sec)
Enter the period (in seconds) from when the
RADIUS server does not respond to when a
timeout occurs. Specify 10 seconds or a value in
the range from 1 to 60 seconds.
RADIUS server2
settings
Same as the
RADIUS server1
settings.
Same as the RADIUS server1 settings.
RADIUS server3
settings
Table 2-59 Action buttons at the bottom
Item Description
Restart
BMC
Restarts BMC.
In addition to BMC re-start, you can turn on the sub-power of the server
blade. If you turn on the sub-power when the main power is on, the main
power is turned off.
Edit Shows the BMC settings available to edit. Select one from the following.
BMC time; Network; BMC User accounts; IPMI/SMASH user accounts; Server
blade Web console; Remote console; IPMI over LAN; SMASH (WS-
Management); SMASH (CLP); Asset information; Edit certificate; SSH Host
Key settings.
If the new value doesn't show up after editing, wait for a while and then click
the Refresh button on the upper right to refresh the window.
Note: When selecting the primary server blade, you can restart either the
primary server blade or all server blades in SMP configuration simultaneously.
Operating the Web Console
2-57
Hitachi Compute Blade 500 Series Web Console User's Guide
To Next Page
Loading...
