Hitachi Compute Blade 500 Series - Page 66

Item Description
CB520H B2 LDAP Ph.
2 or later)
Group DN5
Group DN5 role
(Available only with
CB 520X and
CB520H B2 LDAP Ph.
2 or later)
Search DN (Available
only with CB 520X
and CB520H B2
LDAP Ph.2 or later)
Specify a DN as a starting point to search a
directory when creating a dynamic group.
Search filter
(Available only with
CB 520X and
CB520H B2 LDAP Ph.
2 or later)
Specify an attribute and its value. Group user
entries under the search DN that satisfies the
attribute and its value specified here as a
dynamic group temporarily.
Dynamic group Role
(Available only with
CB 520X and
CB520H B2 LDAP Ph.
2 or later)
Specify a role for group entry. This item is used
for Dynamic group. If a user is not a member of
the dynamic group, a group role specified here
will not be assigned to the user. You can select
a group role from the following 4 roles.
None: No group role is assigned.
Use the role of user entry: Group role is not
used. User entry role specified in Role attribute,
Directory search settings is used.
Administrator: Members of the group can use
each service of server blade BMC.
SMASH: Members of the group can use SMASH-
CLP and WS-Management of server blade BMC.
Table 2-58 RADIUS items
Item Description
RADIUS server
settings
Use Select [Disable] or [Enable].
If you enable this item, RADIUS is used for
SMASH authentications.
If you enable this item, you cannot use the LDAP
functionality.
User
authentication
method
Select a user authentication method.
•
RADIUS authentication only
• If Local authentication fails, try RADIUS
authentication
RADIUS server1
settings
Server name Enter the IPv4 address for a RADIUS server in
the format of XXX.XXX.XXX.XXX or in FQDN
(maximum of 127 characters).
2-56
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide